Problems you may notice
• Refrigerator display shows F15 error code
• Temperature settings are unresponsive or cannot be adjusted
• Inconsistent cooling or warming cycles
• Compressor running continuously or not starting
• Interior temperatures rising above safe levels (above 40°F)
• Freezer section not maintaining proper frost-free operation
• Unusual beeping or alarm sounds from the appliance
• Control panel becomes unresponsive to button inputs
• Ice buildup or excessive condensation inside compartments
Possible Causes
• Faulty temperature sensor in fresh food compartment
• Malfunctioning temperature sensor in freezer section
• Loose or corroded electrical connections between sensor and control board
• Damaged wiring harness connecting temperature sensors to main control circuit
• Control board failure or firmware malfunction
• Power surge or electrical fluctuation affecting sensor calibration
• Sensor positioned incorrectly or blocked by ice buildup
• Defective sensor connector experiencing poor electrical contact
• Control board receiving conflicting temperature readings from multiple sensors
Precautionary measures
• Verify the refrigerator is properly plugged into a grounded 115V outlet (standard USA specification) and the outlet has power
• Ensure both the fresh food and freezer doors close fully with audible clicks and seal properly
• Check that temperature control settings are within normal operating range (37-40°F for fresh food, 0°F or below for freezer)
• Allow the appliance to run for at least 4 hours after plugging in to stabilize internal temperatures and sensors
• Verify the refrigerator is level by checking with a spirit level and adjusting feet if necessary
• Inspect accessible air vents inside both compartments for blockages from food items or ice buildup
• Remove any items blocking internal sensor locations or air circulation paths
• Perform a complete reset by unplugging the refrigerator for 60 seconds, then plugging it back in, or by switching off the dedicated circuit breaker for 60 seconds
• Allow 15-20 minutes for the control system to reinitialize and check if the error clears
• If the F15 error persists after these steps, contact a professional appliance repair technician or independent appliance repair support to diagnose sensor or control board issues
Schedule Service
Fill out the details below — our team will reach out promptly
🔧 All fields are secure • We respect your time