Problems you may notice
• Dishwasher fails to fill with water at the start of a cycle
• Cycle stops prematurely and displays F8X error code
• No water spraying from spray arms during operation
• Dishwasher may attempt to restart the cycle repeatedly
• Standing water or dampness near the base of the unit
• Audible clicking or humming sounds from the inlet area without water flow
Possible Causes
• Kinked or pinched inlet hose restricting water flow
• Clogged inlet water supply valve due to mineral deposits or sediment
• Frozen water line (in cold climates or if appliance is unused during winter)
• Faulty water inlet valve requiring replacement
• Tripped circuit breaker affecting the inlet valve solenoid
• Low water pressure from main supply line
• Closed or partially closed water shutoff valve behind the dishwasher
• Defective water level sensor or float switch
• Internal control board malfunction preventing valve activation
Precautionary measures
• Check the power supply by verifying the circuit breaker is in the ON position; reset it by switching OFF for 60 seconds, then back ON
• Ensure the dishwasher door is completely closed and the latch engages fully
• Locate the water shutoff valve behind or beneath the dishwasher and confirm it is fully open (turned counterclockwise)
• Inspect both the inlet hose connection points (at the wall and at the dishwasher) for visible kinks, twists, or pinching
• Check the inlet hose for cracks or splits by running your hand along its length
• Remove and rinse the inlet filter screen (typically located where the hose connects to the dishwasher) under running water to remove sediment
• Verify that your home's water supply is functioning by checking another fixture (kitchen sink, bathroom faucet)
• Clean the dishwasher's filter basket and spray arms by removing any debris or buildup that could affect water distribution
• Ensure you are using the correct amount of dishwasher detergent and the appropriate cycle for your load type
• Straighten any visible kinks in the inlet hose and ensure it has adequate slack without being coiled too tightly
• If the error persists after performing these checks, contact a professional appliance repair technician to diagnose and repair the water inlet valve or control board
Schedule Service
Fill out the details below — our team will reach out promptly
🔧 All fields are secure • We respect your time