Home / About Us

Fisher & Paykel Washer Error Code 37

Error code 37 typically indicates a water temperature sensor malfunction or heating element issue on Fisher & Paykel washers sold in the USA. This error prevents the washer from reaching the correct water temperature needed for the selected wash cycle.

🔍

Problems you may notice

• Washer displays error code 37 on the control panel and stops mid-cycle • Water does not heat to the selected temperature setting • Wash cycle fails to progress beyond the heating phase • Cold or lukewarm water remains in the drum when hot water was selected • Washer beeps or alerts repeatedly • Unable to start or complete any wash cycle requiring heated water
⚙️

Possible Causes

• Faulty water temperature sensor that cannot accurately read water temperature • Malfunctioning heating element unable to warm water to required temperature • Loose or corroded electrical connections to the heating element or temperature sensor • Broken or damaged wiring harness connecting temperature control components • Water inlet valve not delivering adequate hot water supply from home plumbing • Thermal cutoff protection triggered due to overheating conditions • Electronic control board error preventing proper temperature regulation signals • Sediment or mineral buildup in heating element reducing efficiency (common in hard water areas)
🛡️

Precautionary measures

• Verify the washer power cord is fully inserted into a working electrical outlet • Check your home's circuit breaker panel and reset any tripped breaker serving the washer • Confirm the hot water supply valve behind the washer is fully open and not partially closed • Inspect both inlet hoses (hot and cold) for kinks, twists, or damage restricting water flow • Ensure the washer door or lid is completely closed and latched properly • Verify proper detergent amount and type are being used for the load size • Check that the load is balanced and not overstuffed beyond the maximum capacity line • Run a test cycle using cold water only to determine if the issue is specific to hot water heating • Perform a complete power reset by turning off the circuit breaker for 60 seconds, then turning it back on • If error code 37 persists after these checks, contact a professional appliance repair technician or appliance repair support service to diagnose the heating element or temperature sensor

Schedule Service

Fill out the details below — our team will reach out promptly

🔧 All fields are secure • We respect your time
24/7 Emergency Service

Need Reliable Appliance Repair?

Fast, professional, and affordable repairs for your Fisher & Paykel. Get your appliances working like new — guaranteed.