Fisher & Paykel Washer Error Code E2

• Verify both hot and cold water supply valves are fully turned on (typically located behind or beneath the washer) • Check that inlet hoses are not kinked, crimped, or twisted; straighten any bent sections • Inspect both inlet hoses for visible cracks, leaks, or damage along their full length • Ensure the washer door or lid is fully closed and properly latched • Confirm your home's water pressure is adequate by testing another faucet in your home • Reset the washer by switching off the circuit breaker for 60 seconds, then switching it back on • Verify the washer is properly plugged in and the outlet has power • Check that your circuit breaker has not tripped; reset if necessary • Remove any visible debris or lint from the inlet hose connection points • Ensure you are using the correct amount of HE detergent (oversudsing can trigger sensors) • Confirm the load is balanced and not overloaded, which may affect water distribution detection • Allow water lines to thaw if you live in an area with freezing temperatures If the E2 error persists after completing these checks, contact a professional appliance repair technician to diagnose potential water inlet valve failure or sensor malfunction.